RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050513 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

HINT:: ·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

PROCEDURE

Hide Display 1. PRECAUTION

CAUTION:: Be sure to read Precaution thoroughly before servicing.; Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION201212,999999,_58,_008786,_0049192,RM1000000004DO3,

NOTICE:: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.; Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION201212,201410,_V1,_008731,_0049918,RM1000000004DZ6,201410,201504,_V1,_008731,_0049918,RM100000000HFP9,201504,201510,_V1,_008731,_0049918,RM100000000JQM7,201510,999999,_V1,_008731,_0049918,RM100000000R0XJ,

Hide Display 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:: When disconnecting the cable, some systems need to be initialized after the cable is reconnected.; Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION201212,201311,_V1,_008731,_0049918,RM1000000004DZ8,201311,201410,_V1,_008731,_0049918,RM100000000C1G2,201410,201504,_V1,_008731,_0049918,RM100000000HFOT,201504,201510,_V1,_008731,_0049918,RM100000000JQM8,201510,999999,_V1,_008731,_0049918,RM100000000R0XM,

Hide Display 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL201212,201510,_58,_008791,_0049317,RM10000000048W9,201510,999999,_58,_008791,_0049317,RM100000000RRRI,

Hide Display 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

CAUTION:: When storing the curtain shield airbag assembly LH, keep the airbag deployment side facing upward.

Check that the ignition switch is off.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

1.115,0.552 1.26,0.354 true 1.073,0.979 1.521,1.031 true 1.552,0.948 1.865,1.104 0.313,0.156 10 *1 1.25,0.198 1.563,0.354 0.313,0.156 10 *2

*1	Protective Tape
*2	Connector Lock

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.

NOTICE:: When disconnecting any airbag connector, take care not to damage the airbag wire harness.

Remove the 7 clips.

HINT:: ·

Using needle-nose pliers, release the lock by pinching the 2 locks of the pin, and pull out the pin from the clip.

·

Using 2 screwdrivers, detach the 2 claws by inserting the screwdrivers into the grooves of the clip as shown in the illustration, and then remove the clip from the vehicle body.

Detach the 4 claws.

Remove the 2 bolts and curtain shield airbag assembly LH.

NOTICE:: The bolts must not be reused.

2.313,2.677 2.688,2.573 false 2.385,3.198 2.76,3.094 false 5.021,2.469 5.396,2.365 false 2.698,2.479 3.01,2.635 0.313,0.156 10 *1 2.781,3.01 3.094,3.167 0.313,0.156 10 *2 2.573,1.615 2.885,1.771 0.313,0.156 10 *3 0,0.469 0.156,0.625 0.156,0.156 10 - 5.427,2.271 5.74,2.427 0.313,0.156 10 *2 6.146,1.073 6.458,1.229 0.313,0.156 10 *2 6.917,1.646 7.104,1.823 0.188,0.177 10 *2 5.292,0.563 5.604,0.719 0.313,0.156 10 *2 4.083,0.271 4.396,0.427 0.313,0.156 10 *2 1.896,0.208 2.208,0.365 0.313,0.156 10 *2 1.188,0.083 1.5,0.24 0.313,0.156 10 *2 0.198,0.156 0.51,0.313 0.313,0.156 10 *2 3.042,1.625 3.354,1.781 0.313,0.156 10 *3

*1	Pin	*2	Clip
*3	Bolt	-	-

FaceBox